Bottom Nailling Strip For Wood Siding Shingles

Apply siding to wall assembly directly to wood structural panel sheathing.

Bottom nailling strip for wood siding shingles.

Starter strip should be 4 5 in. Wood shingle siding nailing details. This is a decorative feature that covers the top of the siding where it connects to the soffit. Install the kickout flashing underneath the first shingle photo 1.

You do have to trim the top starter course shingle with a triangle shaped cut to allow this. Put the bottom step flashing on the starter course then bend the bottom of the step flashing out about 1 to 1 away from the wall. This strip of wood or metal is attached to brick stucco or old siding. If desired the starter strip can be cut from the top of the siding and the bottom portion used for the top course.

Siding nail face nailing face nailing is applicable where dictated by building code in high wind areas and when fastening is to osb or equivalent sheathing without penetrating into studs. These strips will receive the nails from the new siding. If the shingle already has flashing on it the kickout flashing has to slip beneath it and you ll have to loosen or remove siding to do this. The indentations profile cut outs of the bottom edge of the first course of siding must overlap.

Fasten a cedar starter strip the same thickness as the top of the beveled siding all around the house using a tape measure and level to set it level along the bottom of the wall. Starting from left to right level and install the siding so the bottom edge is no more than 1 2 inch below the starter strip. Thick and installed to hang below shim approximately 1 in. When nailing shingles proper penetration into the roof deck is essential to ensure the nail and shingle remain secure.

It is used behind siding and trim pieces to protect the backerboard. Patented surenail technology features a wide highly visible engineered fabric strip in the nailing area for a consistent quality installation and the unique product design provides. Add felt if needed before nailing the new wood on and prime the new wood on all four sides before installing it. The top of the step flashing is still under the siding or plaster.

Adapted paraphrased with permission from best practices guide to residential construction. Wood siding shingles and shakes. Begin by nailing a starter strip approximately 3 8 inch thick x 1 1 2 inch wide flush with bottom edge of sill plate.